1968 fastback plymouth barracuda

Plymouth Barracuda 1968 Description

Selling my 1968 plymouth barracud, ar runs and stops but will need minimal brake work performed. All the exterior lighting works but the dash lights and gauges do not because of a problem with the circut board in the dash cluster. Note car is not at this time safe enough to drive on the road because of these problems, ar must be trailered . Car will need the lower quarter panels repaired or replaced and the back corners below the back bumper. It will also need two front floor pans replaced -only a small section just under where you rest your feet. Note this car over all is very solid for being all original. There is a small section of the front left fender on top that will need repaired this is noted in the pictures.and on the lower right side of the trunk lid. This car was in a storage building from 1998 till now . Will need new door panels driver side is missing .Will need new head liner (the bows are there) Over all this would make some one a very easy project to do a complete resto on or just do the small minimal repairs and make it a nice cruiser. This car has some options /front sway bar/wire wheel hub caps/power steering / two tone black and pearl white interior/ side body striping.Drive tran is the original 318 -2bb, 904 trans, -1/4 open rear. Car has a clean maryland certificate of title This car is being sold as is no warranty expressed or applied. Winning bidder is responsible for vehicle pick-up and shipping but I will help any way I can. A 500.00 dollar non refundable deposit at the end of the auction . And full payment within seven day, nd then the automobile can be picked up. Please feel free to call me with questions about the car. And please do not ask me what my reserve is. Note this car is also being sold locally so I have the right to stop the auction early if need be. My cell is 302-420-6647 Joe. Also forgot to mention the front and back glass was out of car. I had the rear glass installed with a new rubber gasket and sealed. The front glass upon installing cracked so i did not seal it in,so it can be easily removed to be replace, Also has a new rubber gasket.And the channel that both of the glass sit in is rust free!!!!!