1979 Jeep CJ7 w/Ford 302 V8

Jeep CJ 1979 Description

1979 Jeep CJ7

Frame-up rebuild beginning in 2003

We are listing this for a friend so if you have any specific questions let me know and I'll get you in contact with the owner. Below is the owners description.

HD Fiberglass tub w/ Kevlar inlays and Rhino bed liner throughout

Ford 302 motor (rebuilt) - built with 302 for later conversion to fuel injection (Mustang 5.0, tc.) (same mounts/bell housing/exhaust)

Edlebrock Intake Manifold

Holley 600 Carb.

In-line, ow pressure fuel pump

Moroso Deep Sump Oil Pan (7 Quart)

T-150 Transmission (rebuilt by Custom Transmission in Copperas Cove, exas)

Dana 20 Transfer Case w/ twin stick conversion (rebuilt by Custom Transmission)

Dana 30 front axle

Dana 20 rear axle

New emergency brake

New disc/drum brakes, rake lines, aster cylinder, alipers, tc. (all new)

New dash, auges, nd wiring (Painless wiring bumper to bumper)

Tom Woods’ Double Cardan (CV) driveshaft (rear)

Tom Woods’ 2” diameter driveshaft (front)

Shorty headers with new exhaust

Summit Racing Starter (1.9 HP 18 Position, /8 Offset)

33x12.50 General Grabber tires (new)

HD steering gearbox bracket

HD steering gearbox stabilizer

New drag link, ie rods, nds, tc.

New Pro Comp 2.5” lift springs w/ ES3000 Shocks

Front roll bar w/ frame tie-ins (all 6 points)

Needs:

Front seal for rear axle ($5 plus labor)

Power steering hoses ($60 plus labor)

*Fuel gauge is new, ut not working. Either a stuck float or loose wire.

Good luck and thank you for bidding. Please do not hesitate to contact me if you should have any questions.

Check out my otherclassic carsI have posted on ebay. !!!!!!!!!!

I also can assist and get discounted rates on shipping w/in the United States or overseas. Let me know where you live and I can get you a quote.