1967 Chevrolet C-10 Truck

Chevrolet C-10 1967 Description

This is a very nice 1967 Chevy C-10 Pickup! This truck has a beautiful black paint job that was obviously done some time ago, ut is holding up very nicely! I dont know what to say other than this in my opinion is a very nicely put together truck, from the wheel selection to the custom covered and colored seat! It has a 400 small block with a Muncie 4-speed that runs strong and smooth! It does have a dead spot with the carbs on take off's that needs tuning but very minor. As you can see in the pictures it has a lot of chrome in all the right places to enhance that beautiful black paint! This IS a driver and it does have its little spots that could use some attention, but all in all this truck is breathtaking. It comes with two Holley 4-Barrel carbs on top of a Edelbrock Tunnel Ram Intake, allory Ignition system as well as lot of chrome decorations for the engine! It appears to have a 2" drop and has already been set up with disk brakes!! It also has new front inner fenders and radiator support. From years past the battery had obviously leaked, o I just replaced it to make it all new again.
This truck is sold AS IS/WHERE IS and is located in the upstate of South Carolina. Please feel free to ask any questions!
The shipping or pick up of this truck is the responsibility of the winning bidder. I accept cash, ashiers check, r paypal. Half of the winning bid amount is due with in three days after auctions end. The remaining balance is due with in one week or when the truck is picked up which ever comes first.

On Mar-21-16 at 15:26:08 PDT, eller added the following information:

Folks I am receiving a tremendous amount of interest in this little truck and I am very appreciative. I have added some pics and will be adding more before the auction ends. Pollen is heavy here and it is hard to keep it clean long enough to get a dust free pic. I have been asked about rust, nd the only places that I see rust is at the bottom of the rockers there are little speckles that appear to be the early stages of rust and will probably have to have some attention in the future. I really never noticed until someone asked about it, ut it will be an easy mask out and repair. I have a pic that you may be able to see what I'm talking about and will try to get a better angle and post that as well, ut as far as the rest of the truck it appears to be rock solid. There is also one pic that you may not be able to tell what it is, ut that is the underside of the floor pan. The truck has no gouges, cratches or dents and the inside of the bed is very very nice! More pics to come.